Material Handling Power UNIT one
This energy unit is created for that fork lift marketplace, consisting of highly effective gear pump, DC motor, manual increase and decrease valve, tank, ect. The up and down movement are controlled from the lever of the guide release valve, and that is equipped with an electric switch to activate the motor. The lowing velocity is managed from the strain compensated flow control valve.
one. The duty of this electrical power unit is S3, i.e. thirty seconds on and 270 senconds off.
two. Clean the many hydraulic components concerned just before set up of the power unit.
3. Viscosity in the hydraulic oil shoud be 15~46 cst, which really should also be clean and absolutely free of impurities, N46 hydraulic oil is proposed .
four. Oil changing is required following the initial one hundred operation hrs, afterwards once every single 3000 hrs.
5. The electrical power unit proven is built to be mounted horizontally.
Material Handling Power UNIT two
This electrical power unit functions power up gravity down circuit. Activate the start solenoid to begin the motor to lift the machine. The lowing movement is activated by the solenoid valve using the reducing speed controlled through the strain compensated flow handle valve. Solutions of this series may be broadly used in the field of logistic products including fork lift, mini lift table, etc.
1. The duty of this energy unit is S3,i.e.,30 seconds on and 270 senconds off.
two. Clean all of the hydraulic elements concerned in advance of mounting the electrical power unit.
three. Viscosity of the hydraulic oil shoud be 15~46 cst,which ought to also be clean and absolutely free of impurities, N46 hydraulic oil is encouraged .
four. Oil changing is required soon after the original 100 operation hrs,afterwards once just about every 3000 hrs.
5. The energy unit needs to be mounted horizontally.