Energy UNITS FOR LIFT TABLE 1
Common Description
This power unit is developed solely to the tiny lift table,Consisting of higher strain gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This power unit is broadly used in the business of logistic gadgets for example minifork lift, scissors lift and ariel working platforms. The lower-ing movement is controlled from the solenoid valve using the velocity controlled from the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
General Description
This electrical power unit is made solely for that medium lift table, Consisting of remarkably effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing motion is actived from the solenoid valve along with the speed controlled from the adjustable needle valve. Once the lift rises to a substantial positoin, however the energy supply is reduce, the lowering motion is managed through the manual override perform.
Electrical power UNITS FOR LIFT TABLE three
General Description
This energy unit is intended solely for your significant lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived from the solenoid valve plus the pace managed by a pressure compensated movement management valve.
Electrical power UNITS FOR LIFT TABLE 4
Standard Description
This energy unit is intended exclusively for the large lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived by the solenoid valve and the speed managed from the adjustable needle valve. When the lift rises to a high positoin, but the electrical power supply is reduce, the reducing movement is managed by the manual override function.
Special Notes
one. This electrical power unit is of S3 duty cycle, which could only perform intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean the many hydraulic components concerned before set up of the energy unit.
three. Viscosity on the oil shoud be 15~46 cst,which ought to also be clean and no cost of impurities.N46 hydraulic oil is proposed.
4. Oil transforming is required following the initial a hundred operation hours,afterwards after every single 3000 hours.
5. The energy unit shown is created to be mounted vertically.